The unit is intended for mechanical purification, degassing, thermovacuum drying (dewatering), as well as for leaktight storage, transportation and pressurized pouring of oil in various facilities (both hermetic and
The unit is used to purifiy turbine-, industrial and compressor oils.
Technical data
Capacity, L/h (depending on the oil viscosity)
|
250
|
Treated oil characteristics (given an initial moisture weight fraction of not in excess of 0.1% and mechanical impurity grade not more than 15 to 17 cl.)
|
|
Moisture weight fraction , %
|
10
|
Moisture gas fraction ,%
|
0,2
|
Filtering rating, mcm
|
5
|
Mechanical purification grade, cl
|
|
Range of temperature adjustment during treatment / recommended temperature, 0С
|
|
Degassing tank volume, L
|
70
|
Residual pressure in degassing tank, mm merc. col.
|
20
|
Liquid elevation, m
|
40
|
Three-phase 50 Hz mains voltage, W
|
380
|
Operating temperature range, 0С
|
0…+40
|
Full weight, kg
|
80
|
Sizes (LxWxH), mm
|
700х500х850
|
* in the «automated continuous» mode
«manual batched»: oil is pumped into the degassing tank by 10 to 50 L batches, treated as required and pumped out through the filter (for this mode, preparing 50 L of oil as per the GOST requirements takes 30 minutes).
«automated batched»: 50 L of oil is pumped in, degassed and then pumped out (the mode is fully automated. The mode capacity is 250 L/h).
«automated continuous»: the oil passes through the tank as a continuous flow, which through the fine filter heads for the unit outlet (The mode capacity is 500 L/h).